Microbeast PLUS – Download; Microbeast PLUS – Download. Download Introduction Q A - Wiki. Update Instruction. Please be noted and make sure to follow the firmware update procedure, in correct procedure may result in serious damage or update failed. Please refer to Firmware Update Procedure. 2. Download Update Software and Install. Supported operating systems are: Windows (XP, Vista, 7, 8, ) MacOS x and later 3. Driver installation. Windows: The driver installation will not be launched automatically during setup. The installer will be copied and a . Manual installation of interface driver. First of all make sure the USB2SYS interface is disconnected from the computer. Then download the driver installation package for your device: Save the file "CPx_VCP_bltadwin.ru" to your harddisk and open the downloaded zip-file from the folder where it has been saved to.
StudioX / StudioXm is the app that allows to fully configure your MICROBEAST PLUS, Spektrum ARBX and NANOBEAST. You can use it to do all the configuration from the computer or smartphone, to backup settings, load preconfigured setups and do a lot more. The PC/mac software can also be used to update and configure your BLE2SYS bluetooth smart. Usually if there is an issue with connecting the Kbar to the software it is to do with the software drivers - look in Device Manager and see if there is a little question mark showing for one of the devices (I think that it is in the USB section). There are instructions on how to load the drivers elsewhere in this thread. I meant that the beastx software is version and the hb is running firmware. I wouldn't know if the beastx would able to work with the hb firmware well maybe it is a luck thing that it did not update for you because from what i have heard it will brick (render it useless) it, BUT.
The StudioX software can be used to configure, backup, restore and update any BEASTX flybarless system with your computer. Also you can purchase firmware upgrades for additional functionality. Please note that you need to register to the freakware Network from within StudioX to get online content like firmware updates for your devices. The new BeastX flybarless system. ENG. DEU. Helicopter presets for BEASTX flybarless devices; SRXL - Serial Receiver Link protocol; How-Tos. Internal RPM Governor - Governor setup with a Castle Creations ESC; Internal RPM Governor - How to modify ALIGN rpm sensor (HE50H22) for nitro helis; AttitudeControl - Transmitter setup and function assignment; USB2SYS / RX2Sim - Driver installation.
0コメント